Overview of the 500ARV Plus
Large Scooter
The Tilt-a-Rack® Scooter
Carrier 500 RV Plus makes transporting even the largest
four-wheeled scooters effortless. The Tilt-a-Rack®
Scooter Carrier is easy to install and use. There are no
electronic components. Gravity and balance work for you!
- 63" x 38" usable
space...this is the only outside lift available that
will handle the Pride Wrangler PMV.
- The carrier has a hinging
device located just behind the hitch. The hinging
device has three positions. Each position uses a 5/8"
pin. The first position keeps the rack locked in the
horizontal position. The second position allows the
loaded scooter rack to lift and float over dips and
curbs. The third position will permit you to store the
rack in a vertical position.
- The leveling bolt on the
frame beneath the platform keeps the carrier level for
each type of vehicle and levels the center of gravity
of the many types of chairs and scooters.
- The tilt feature eliminates
the need for ramps. With the flip of a latch, the rack
tilts easily toward the passenger side. It
conveniently reaches the curb for parallel parking.
The deck extender pulls out from beneath the scooter,
reducing the angle of incline. This feature is
especially helpful when a handicap curb is not
available.
- The two set bolts eliminate
the minute movement of the hitch bar when inside the
hitch receiver. They are tightened to the face of the
receiver immediately after you attach the carrier to
your vehicle. Works with a 2" class III hitch
(standard). If you have a class II 1 1/4" trailer,
just add the optional Class II hitch bar.
- For low or smaller vehicles, add the
height-adjustable Class II or III hitch bar.
