| |
A Side Entry Lift, the Scooter
Lift II Loads
into Vans and Minivans
Scooter-Lift II - What is it?
This fully powered lift is ideal
for raising and storing a fully-assembled scooter or
wheelchair into the sliding side door of minivans, as well
as the passenger side door of full-size vans. Simply
connect the docking device to your scooter or wheelchair,
and effortlessly raise and store with the hand-held
pendant
•Ideal for raising and storing a
fully-assembled scooter or wheelchair into the driver or
passenger (sliding) side door of minivans, as well as the
passenger side door of full-size vans.
•Requires very little arm strength, balance or effort to
use. It’s so compact that even when you use it in a
minivan, there is still enough room for three passengers
to sit comfortably in the rear seat. With the scooter
removed, or when traveling without the scooter, entry and
exit is easy since the door opening remains unobstructed.
•Features an optional installation assembly that
eliminates the need to drill holes in the floor of the
vehicle. This allows easier removal when it comes time to
transfer the lift in and out of a minivan.
•Can be used for either three- or four-wheel scooters as
well as manual-folding or power wheelchairs weighing up to
200 lb/90 kg. The hand-held controller makes this lift
simple and easy to use.
•Powered by your vehicle’s battery and all lift operations
are automatic - just help guide the scooter or wheelchair
into place.
•Can be powered by the vehicle's battery or the optional
Bruno Pow'rPac (a self-contained power supply that is
charged through the vehicle's power port). Allows unit
operation even if vehicle battery is inoperable.
Recommended for hybrid vehicles with small accessory
batteries.
•Sales, installation and service provided by our
factory-trained worldwide network of dealers
•Bruno Turning Automotive Seating™ (TAS™) complements your
vehicle lift for a total mobility solution
•Up to $1200 is available to help pay for a vehicle lift
through Mobility Reimbursement Programs
To use this lift, the consumer
(end user or attendant)
must be physically able to do the following:
- Connect/disconnect docking
device to mobility device (may require good hand
dexterity). This could be done by:
- Leaning over from a
standing position
- Sitting in the vehicle
seat and leaning out of vehicle
- Sitting on the Turny/Turny
Orbit seat and leaning over
- Hold down a button on a
hand-held pendant while gently guiding the mobility
device as the lift pulls it into/out of the side
door of the vehicle
- Fold down the seat back
and/or tiller of the mobility device, or remove the
seat back using the Back-Off device, if applicable.
|
Scooter-Lift_II_Lift.pdf
 |
