||MicroAIR Alternating Pressure Overlay
Alternating Pressure Overlay
Product ID: MA50
HCPCS Code: E0372**
HMESA CODE: 10-10-09-00
Glossy Sell Sheet
|MicroAIR Alternating Pressure Mattress Replacement with 10 LPM
For pressure ulcer treatment
View the Bed Rail Entrapment Risk Notification Guide
10 LPM compressor
Overall Length: 80"
Overall Width: 36"
Overall Depth: 5 inches
Flammability: 16 CFR 1632 and 16 CFR 1633 compliant
Pressure Mattress Overlay System
Economical alternating pressure mattress overlay
The MA50 is a Group I support surface and has a 350-lb
The microAIR MA50 APM provides pressure relief in the
prevention and treatment of pressure ulcers. This
Alternating Pressure Overlay System attaches to the
top of a standard mattress. The MA50 mattress is 5"
high. This 5-inch additional height may effect bed
rail's usable height or functionality.
The microAIR MA50 is a good cost effective overlay
system. This powered mattress overlay has 16 five inch
bladders covered in 70 denier quilted nylon for
comfort. Treatment times are 5, 10, 15, and 20 minute
cycles. The non-skid bottom is secured with elastic
hold-downs. When rolled up for storage, carrying
handles allow for easy transport.
microAIR Control Panel:
microAIR Control Panel. Treatment times are 5, 10,
15, and 20 minute cycles.
The alternating pressure times indicate the frequency
of deflation or inflation of half of the air cushions
(even or odd numbered). For example, 10 minutes is
selected. In this example, the even numbered air
cushions in the mattress will deflate, while the odd
numbered cushions remain at constant pressure. When 10
minutes has elapsed, the even numbered air cushions
will inflate while the odd numbered cushions remain at
constant pressure. When 10 minutes has elapsed again,
the odd numbered air cushions deflate while the even
numbered cushions remain at constant pressure. The air
cushions continue to inflate or deflate like this as
long as an alternating pressure time has been
selected. At all times, half of the air cushions
remain at a constant pressure when an alternating
pressure time has been selected.
all air cushions in the mattress are maintained at
constant pressure. The Static LED is illuminated
The minimum pressure setting during Alternating
Pressure is set to 0 (2 mmHg) at the factory. This
means that the mattress will deflate as much as
possible during the deflation time when using 10, 15
or 20 minute Alternating Pressure times. The setting
can be changed so the mattress will only deflate to
50% of the selected pressure setting.
microAIR Mattress Overlay:
The waterproof cover is made of non-shear nylon and
has nylon tie down straps with buckles for attaching
the mattress to the bed. The mattress has a 16
bladders, each bladder is 6" thick. In addition,
there is a 2" foam safety pad under the nylon cover.
This microAIR mattress overlay has a non-skid bottom
and is secured with 10 nylon web buckled hold-downs.
When rolled up for storage, carrying handles allow for
Hospital/Homecare Bed Size:
Affordable with added comfort, this alternating
pressure mattress is available in the standard 36" x
80" size (Twin XL).
Invacare MA50 Alternating Pressure Mattress